Light Speeder Truck - The "Mule"!

The "Mule"! A fun collaboration between Squamous Miniatures and The Ataraxy Emporium!

Need a light speeder truck for hauling goods around town or hauling critical starship fuel to the starport? Look no further than this S-10 of the stars!

This particular ride just happens to be pride and joy of one bad-mutha-alien-trucker, "Puro Stogie", sculpted by the world renowned Squamous Miniatures! Make sure to pick up this awesome figure at: https://SquamousMiniatures.gumroad.com

We provided two cab versions for this model: the full cab will require Puro and the dash to use magnets in order to fit properly; however, the drop-top cab can be glued in place permanently along with Puro and the dash, if desired. Instructions are included - I make it sound way more complicated than it is...

Magnets! - you'll need approximately 30 neodymium disc magnets to fully take advantage of the modularity of this kit. Size should be 1/8" diameter by 1/16" thick. These can be obtained relatively inexpensively from eBay.

Stand & Base - a short stand has been included in this listing to place the speeder truck at an appropriate "hover" distance above the ground (we haven't figured out how to print out working repulsors yet). This stand is intended to be used with a 100mm base (not provided - I'm sure you have your own favorite 100mm base if you're reading this ;)

-This 3D vehicle model was inspired by 2D artwork created by Christian Piccolo. Please check it out here: https://www.artstation.com/artwork/KEa9R

As well as his other super-cool art here: https://www.artstation.com/cpiccolo

-This model is scaled to approximately 1/48 and is suitable for various tabletop miniature games.

-You will receive all models to produce the poses shown in the pictures.

-You will receive multiple STL files in this purchase, with and without supports.

-This product contains digital files only - no physical items are offered unless specifically noted in the listing. Files are intended to be printed in an SLA printer and have been tested with an Anycubic Photon, 0.04mm layer height, bottom layer count 3, exposure time 8 seconds, bottom exposure time 30 seconds, light off delay 0 seconds, bottom light off delay 0 seconds, bottom lift distance 5mm, lifting distance 5mm, bottom lift speed 60mm/min, lifting speed 60mm/min, retract speed 150mm/min, Siraya Tech Fast resin and Siraya Tech Tenacious Resin mixed 75%/25% respectively. Print time approximately 5 hours. Be sure to clean thoroughly with 90% Isopropyl Alcohol and a soft tooth brush prior to curing to prevent residue washing out details.

- Upon purchase, the end-user agrees to use these products for personal use only.

- You may not: use these products for commercial purposes; resell these products after purchase (or any remixed derivatives); or share these products in any way.

THIS PRODUCT MAY BE A DERIVATIVE AND TRANSFORMED EXPRESSION OF EXISTING ART AND SHALL NOT BE USED IN PLACE OF ANY OFFICIAL PRODUCT OR COPYRIGHTED ART FORM.